SINJI SIAC-0109 - Operation Instructions; General; Filling; Ice Packs

2. Operation instructions
2.1 General
Completely uncoil the power cord and plug the heater directly into a 220240 Volt grounded AC wall outlet.
Be sure that the plug fi ts tightly. A loose fi t can cause overheating and damage the plug. The plug and power
cord may feel warm during normal usage.
2.2 Filling
Warning: Always unplug the Sinji Aircooler before fi lling!
Warning: Do not fi ll above the “Max” water level indicator.
Warning: The water level should not fall below beneath the “Min” water level indicator, unless the Sinji
Aircooler is turned off.
Lift the lid of the Ice Pack compartment. Use a separate water container to slowly fi ll the water tank. Do not fi ll
too fast or let it overfl ow, this will harm the electrical components. The front window of the water tank shows
the water level.
2.3 Ice Packs
The Ice Packs help cool the water in the Sinji Aircooler to more effectively cool the air, but they are not needed
for the Sinji Aircooler to function.
Place the Ice Packs in the freezer for at least 4 hours. Once the Ice Packs are frozen, you can place one in the
Ice Pack Compartment under the lid at the top part of the Aircooler. Place it in the slot indicated in the second
Ice Pack can be used to replace the fi rst one when it has defrosted. This way you can ensure constant cooling
throughout the day.
EN