SINTERIT Lisa X - Technical Specification

Sinterit LISA X Short User Manual | 11
IMPORTANT!
Keep the suction hose inlet just above the powder surface.
4.2 Cleaning the Overow bin
ATTENTION!
Attempting to slide the Overow bin back into the printer without unlocking the security
system may damage the drawers mechanisms.
IMPORTANT!
Make sure the Overow bin is oriented correctly once you put it back. Pay attention to the markings
on the bin.
1. Press UNLOCK DOOR on the screen and open the door.
2. Press UNLOCK OVERFLOW on the screen. Remember,
you only have 10 seconds to remove it before the lock
activates again.
3. Slide out the Overow bin (g. 4.2).
4. Take the Overow bin from its drawer and transfer its
contents onto the Multi PHS worktop or into the Metal
container.
5. Put the Overow bin back in its drawer.
Fig. 4.2 Sliding out the Overow bin.
6. Press the UNLOCK OVERFLOW button to release the lock and slide the drawer back into the printer.
7. Close the printer door and press DONE.
8. If you want to know how much fresh powder you need to add to the used powder press SHOW REFRESH INFO.
If you wish to instead do that another time, press SKIP.