SINTERIT Lisa X - Powder First Aid Procedures

Sinterit LISA X Short User Manual | 9
1. Press the RESET button on the printer, to activate the security system.
2. Press START PRINT. Before printing, an automatic component check will be performed.
3. You can stop the process at any time, just press ABORT PRINTING.
3. REMOVING AND CLEANING THE PRINTOUT
1. When removing the printout is possible, the REMOVE PRINTOUT button will be displayed. Press it.
2. The screen may display a message about the maintenance time of the components. For more information see the
full user manual, chapter 13. If the message hasn’t appeared, it means that no components require any maintenance.
Press GOT IT.
3. Press UNLOCK LID on the screen to release the electrolock and allow the printer to be opened. Remember, you only
have 10 seconds to open it before the lock activates again.
4. Push on the lid and pull it up using the handle (g. 3.1).
Fig. 3.1 Lifting the printer lid.
5. Make sure no miscellaneous items remain in the print
chamber and press POSITION BEDS.
6. Place the folded IO BOX inside the print chamber. Ensure its
elements are arranged like in the picture (g. 3.2).
FEED BED PRINT BED
Fig. 3.2 The proper arrangement of the IO BOX.
ATTENTION!
While placing the IO BOX in the chamber, make sure you do
not accidentally damage its components.
7. Unfold the IO BOX elements as much as possible. Inside the IO BOX, you
should see a covered Feed Bed and an uncovered Print Bed.
8. Press REMOVE PRINTOUT on the screen and wait until the content of the
Print Bed (the cake) is ejected.
9. Close the IO BOX (g. 3.3).
Fig. 3.3 Closing the IO BOX.
10. Carry the IO BOX and its contents onto the foldable tray
1
or to the Multi PHS worktop
2
(g. 3.4).
11. Press DONE on the screen.
12. Clean the printout of unsintered powder. You may use the accessories provided in Dedicated Powder Tools.