SIP 50000250 - Mounting and Setting Instructions for Speed Sensor (Part No. 50000250); Initial Removal and Preparation; Sensor Installation into Suspension Arm; Connecting Sensor and Securing Cables

12-13
Remove the original speedometer cable,
rubber and fixing plate from the suspension
arm.
Step 1
Place the included rubber gasket and speed
sensor into the suspension arm.
Step 2
Push the gasket completely into the
connection.
Step 6
Attach the sensor to the old speedo cable
with sticky tape and pull it through the
steering column.
Step 4
Step 3
Mount the speed sensor with the screw,
locking ring and washer that are included.
In the case of resistance,
carefully turn the wheel.
CAUTION!
Position the rubber gasket over the cable
connector followed by the cables.
Step 5
Pay attention to wire colour
and order.
CAUTION!
Cable colours:
1- black, 2 – red, 3 – white
1 2 3
MOUNTING- AND SETTING INSTRUCTIONS SPEED SENSOR (PART NO. 50000250)
3.1