Need help?Do you have a question about the Sirona inLab MC XL and is the answer not in the manual?
General| Brand | Sirona |
|---|---|
| Model | inLab MC XL |
| Category | Dental equipment |
| Language | English |
Defines hazard symbols like DANGER, WARNING, CAUTION, NOTICE.
Explains document formatting and symbols for clarity.
Details CE mark, EAC, GOST, and RoHS compliance certifications.
Specifies the unit's purpose and restrictions, including US regulations.
Covers prerequisites, installation site restrictions, and product modification prohibitions.
Warns about instruments continuing to run when the door is opened during operation.
Prohibits the use of mobile phones to ensure safe operation.
Instructions for safe transport, unpacking, and incoming inspection.
Guidance on disposing of packaging according to national regulations.
Specifies requirements for unit placement, including distance from patients and ventilation.
Notes initial startup and software installation requirements.
How to configure unit settings via the "inLab SW" software.
Instructions for calibrating the unit, including prerequisites and steps.
Introduction to the production process and material selection.
Instructions to start the machining process, including block insertion.
Instructions for securing blocks using the clamp tool and ball pressure screw.
Details clamping procedures for 6mm block holders and adapter sleeves.
Recommendations for weekly machine care, including filter changes and cleaning.
General information on water changing, preventing odors, and approved additives.
Procedure for replacing instruments when prompted by the system.
Steps to change filter inserts for non-base metal materials.
Safety and disposal instructions for base metal materials and filters.
Steps for cleaning and preparing the external water tank.
Steps to remove water using the pump for non-base metal materials.
Steps to remove water for base metal materials.
Instructions for using the tank cap opener for the tank cap.
Instructions for using the tank cap opener for the filter cap.
Specifies the required PC hardware and software for the unit.
General technical description of the grinding and milling unit's features.
Technical data including voltage, power, dimensions, and weight.
Instructions for returning and disposing of old electrical and electronic devices.
To Next Page
