Siruba C007KP - Adjusting Presser Foot; Adjusting Stitch Length

P26
Introduction
A
2
3
4
1
1
壓具之調整 ADJUSTING PRESSER FOOT
圖 22/Fig.22
( 圖 23)
(Fig.23)
(NEEDLE)
2
1
圖 23/Fig.23
針
縫目長度之調整 ADJUSTING STITCH LENGTH
縫目長度由 1.4~3.6mm 或 7~18 針 / 英吋
無階段性調整。( 圖 24)
1. 用手調整旋轉鈕
①
即可調整縫目長，調
整範圍 1.4~3.6mm，相當於最大行程
為 7 針 / 英吋，最小行程為 18 針 / 英吋。
Stitch length can be adjusted variably in
range from 1.4~3.6mm or 7~18 stitches per
lnch.(Fig. 24)
1.Adjust the rotary knob
①
by hand to adjust
stitch length. The adjustable range is
1.4~3.6mm which is equal to the maximum
stroke 7 stitches per inch. The minimum
stroke is 18 stitches per inch.