P34
Introduction
圖 33/Fig.33
表 5/Table 5
針之更換 REPLACE THE NEEDLE
1. 選用針之規格與尺寸請參照 ( 表 5)
2. 旋開螺絲①並取下針，將新針插至針座最底
端，並使針之長溝面向自己。( 圖 33)
3. 重新鎖緊螺絲①。
* 特殊機種針之代號請參考規格件表。
1.See table 5 for the sizes and the specifications
of the needles.
2.Loosen screw ① ,then pull out the used
needles.Insert the new needles into the holder
holes as far as they can go,and let the long
groove of the needle face you.(Fig.33)
3.Fasten screw ① .
*Needle size of special model,please refer to
conversion chart.
To Next Page
Loading...
Need help?
General
