.
1.
6 ,
撚
.
2.
,A .
3.
, , 50mm .
8 The threading of bobbin thread(Fig.6 and 7)
To make bobbin thread go through the eye of the needle in the order as shown in (Figs.6 and 7)
1.
Make the bobbin thread go through the tensioner guide plate; go through the two holes when
thread of harder twist fibre is used and feed gauge is wider than usual.
2.
Pull the spring toward the operator, as shown in Fig.7 and part A will rise awards
3.
When threading the looper, the thread shall be made go through the eye of the needle with a
tweezer as shown in Fig.7 and 50mm of remaining thread be pulled out
To Next Page
Loading...
