4.3 Tips on handling speakers
We recommend you to set up the speakers in a way, that their sound signals can reach the
audience unobstructedly.
Always use high grade cables to connect your equipment. Otherwise you won't reach max‐
imum sound quality.
For optimum results both impedance and power handling of the speakers must match the
requirements of the amplier. Always follow the technical specications of all equipment
involved!
The overall impedance of the connected loudspeakers must not deceed the minimum output
impedance of the amp. The amps max. RMS output power should be 50 % above the power
handling capacity of the connected speakers.
If you notice distortion during operation, either the amp or the speaker is overloaded. This may
permanently damage the amp or the speaker. Always reduce the volume as soon as you notice
distortion.
Installation
Drop 4, drop 6, drop 8
15
Passive Speaker
To Next Page
Loading...
