En
01-2020
®
Siser Craft Heat Press
Model CP912-120
Operator’s Manual
instruction concerning use of the appliance by a person responsible for their safety.
When using your heat press, basic precautions should always be followed,
2. Use heat press only for its intended use.
1. Read all instructions.
4. Never pull cord to disconnect from outlet, instead, grasp plug and pull to disconnect.
5. Do not allow cord to touch hot surfaces, allow heat press to cool completely before storing.
qualified service person for examination and repair. Incorrect assembly or repair could increase the risk
of fire, electric shock, or injury to persons when equipment is used.
To reduce the risk of electric shock, do not disassemble or attempt to repair the heat press. Take it to a
Safety Precautions
3. To reduce the risk of electric shock, do not immerse the heat press in water or other liquids.
6. Do not operate heat press with a damaged cord or if the equipment has been dropped or damaged.
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
7. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or
including the following:
10. To reduce the likelihood of circuit overload, do not operate other high voltage equipment on the same circuit.
11. If an extension cord is necessary, then a 10 amperage rated cord should be used. Cords rated for less
8. Close supervision is necessary for any heat press being used by or near children. Do not leave equipment
unattended while connected.
over.
9. Burns can occur when touching hot metal parts.
amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped
To Next Page
Need help?
General
