IP Filter
Filter Type
Choose the type of filter you wish to use, there are 3 possible types of
filter .
- IP/Mac Filter
- Application filter
- URL block
IP Filter Rule Editing
• IP Filter Rule Index: This is item number
• Active: Select Yes from the drop down list box to enable IP filter rule.
• Source IP Address: The source IP address or range of packets to be
monitored.
• Subnet Mask: It is the destination IP addresses based on above
destination subnet IP
• Source Port Number: This Port or Port Ranges defines the port allowed
to be used by the Remote/WAN to connect to the application. Default is
set from range 0 ~ 65535. It is recommended that this option be
configured by an advanced user.
To Next Page
Loading...
