To operate the machine, gently depress the motor switch by
pushing hardest on the side of the switch that points to the
desired direction of the cut. Release all pressure from the switch
and the rollers will stop moving. (Note: The machine moves in
forward and reverse, allowing for reversal of direction at any
time. This also makes for convenient loading and handling of
shape-cutting products from either end of your Big Shot Express.)
CAUTION
: Do not attempt touch or removal of the
shape-cutting products from the Big Shot Express until you have
released all pressure from the motor switch and all materials are
clear of the rollers. Then, and only then, is it safe to remove or
handle your die and die-cut shape.
Using the Big Shot Express
To Next Page
Loading...
