SIZZIX BigKick User Manual

Handle
The Sizzix
®
BIGkick™ is exactly what crafters have been looking for –
a versatile, easy to use and affordable multipurpose creative system.
Designed to cut and emboss for creating unlimited fun projects. Using
the Sizzix Originals™, Bigz™, Sizzlits
®
, Clearlits™ and Embosslits™
Dies as well as Simple Impressions™ Embossing Folders, crafters
can now express their creative voice in minutes. Start unleashing the
limitless possibilities of your BIGkick to create a combination of
dazzling designs.
Place Sizzlits Die onto a Cutting Pad with foam
side up. Place paper over the die. Place another
Cutting Pad over the paper to create a
“sandwich.” For Clearlits Die, place die over photo
or material so that the area to be cut shows
through the die. Then place photo or material and
die between Cutting Pads to make sandwich.
Cutting
Pads
Paper
Die
Multipurpose Platform
(Tab 1)
TM
TM
Before attaching handle, remove protective
cap on crank shaft and discard. Then
attach handle by sliding washer over hex
screw and insert through handle and into
crank shaft. Tighten hex screw with hex
wrench provided with handle kit. Press end
plug over hex screw until firmly sealed.
Assembly Instructions
Place sandwich on Multipurpose Platform and slide
Platform into opening of BIGkick. Note the rotation of
the handle and continue to rotate it in the same
direction until the Platform has passed through the
opening and the rollers. Remove Platform from
BIGkick. Your die-cut shape is ready to use!
“Sandwich”“Sandwich”
Multipurpose Platform
Page 1 of 3
Using a Sizzlits or Clearlits Die

SIZZIX BigKick Specifications

General

Compatibility	Sizzix dies
Maximum Cutting Width	6 inches
Compatible Materials	fabric, leather, paper, cardstock
Type	Manual Die Cutting Machine
Color	White

Summary

Sizzix BIGkick Assembly and Introduction

Assembly Instructions

Guide for attaching the handle, removing the protective cap, and securing the hex screw.

Using Sizzlits or Clearlits Dies

Prepare the Cutting Sandwich

Layer Sizzlits Die, paper, and two Cutting Pads with foam side up.

Operate the BIGkick Machine

Slide the platform through the BIGkick rollers, rotating the handle until the sandwich passes.

Using Originals or Bigz Dies

Create the Cutting Sandwich

Place Die, material, and two Cutting Pads. Do not use the Multipurpose Platform.

Process the Sandwich

Slide the sandwich into the BIGkick opening and rotate the handle until it passes through.

Using Embossing Folders or Embosslits Dies

Prepare the Embossing Sandwich

Insert material into folder, close, and create a sandwich with Cutting Pads.

Use Multipurpose Platform

Place sandwich on platform for 4"+ folders; omit for 2 1/2" folders.

Emboss with BIGkick

Slide platform sandwich through BIGkick rollers and remove to get the embossed design.