SJCam SJ4000 WiFi Manual
2016 January 6
Revision 4
GENERAL NOTES
- When you open the camera package for the first time check the contents to make sure you
have all the mounting hardware and accessories.
- Plastic film covers the camera display and lens. There is also plastic film on the inside and
outside of the lens cover and both back cover doors of the clear housing. Remove plastic film
before using the camera.
- Verify the authenticity of the camera by checking the security code under the scratch-off on
the side of the package. Go to the SJCam official website at http://www.sjcamhd.com/safe/
and enter the security code as directed to verify that you have an authentic SJCam.
- This manual is based on firmware version G20150408V02 dated 2015 April 8. Camera
menus, settings or other operations might vary with other firmware versions.
- Notes are identified in parentheses () and are described at the end of each section.
1. EXTERNAL LIGHTS
The following lights indicate the operation described and can occur in several combinations.
- Blue light on: camera is on
- Red light on: camera is connected to a charger
- Amber light on: camera is connected to a smart device via WiFi
- Blue light flashing: camera is recording video
- Amber light flashing rapidly: camera WiFi turned on but not connected to a smart device
- Amber light flashing: camera is connected to WiFi while recording video
- Red and amber lights on while charging: WARNING – There is a serious problem with
charging. Disconnect charger immediately due to the danger of severe overheating.
1. EXTERNAL LIGHTS 2. BUTTONS
- PAGE NO. 1 OF 32 -
To Next Page
Need help?
General
Weight and Dimensions
