LIGHTSET › To change the number of LED status-indicator lights that are active.
3 is to activate Front, Top, Back indicators, 2 is for Top and Back, 1 is for Back only.
0ff turns off all status-indicator lights.
SCREENSAVERS › Options for the duration to save Screen-On time.
FREQUENCY › For adjusting the framerate frequency to counter the flicker-effect
caused by TV systems with different refresh rates (PAL/NTSC).
DASHCAM › Enables automatic power on and recording when engine is started.
WIFI SSID › For changing the WiFi name of your camera. Default is 12345678, you
can change this to anything anytime you wish.
WIFI PASSWORD › For changing your camera’s WiFi password. (Wifi version only)
SETUP MENU - Screen 5 of 6
Lightset
Screensavers
Frequency
Dashcam
WIFI SSID
WIFI Password
Note: Screen arrangement and feature availability may vary depending on rmware version.
TIP: When using your camera as
a dashcam, use a car charger
cable and remove the internal
battery to make sure it does not
die out while you travel.
CAUTION: Operating your camera
while driving a vehicle is
potentially dangerous.
It is strongly advised to set up
your camera before your trip.
5/6
Setup
>
>
To Next Page
Loading...
