BASS BOATS
3-31
FILLING THE LIVEWELL –
2-WAY VALVE SYSTEM
Livewell Fill Water Flow
Figure 3-14
Before filling the livewell, make sure of the following:
• Transom strainer(s) are clean and secured to the
water inlet on the transom.
• The boat is in the water, at rest position with
unrestricted water flow to the water inlet on the
transom.
NOTE: The livewell cannot be filled while the boat
is running.
To fill the livewell:
1. Close the actuator to the livewell. The actuator
opens and closes the livewell drain valve.
2. Open the fill valve inside the livewell. The fill valve
is located on the fill nozzle at the top of the inside
of the livewell.
SKE-0027-A
OVERFLOW
PUMP-OUT
FILL
REMOTE DRAIN
VALVE
Section 3_2012_Section 3_horiz.qxd 2/22/12 12:01 PM Page 3-31
To Next Page
