11. System configuration
11.7 Setting parameters to default
Set Params to Default
Step Key Display Description
System configuration / Set Params to Default Activating Set Params to Default resets the selected lubrication system.
Entries made by the customer or Service will be overwritten.
1
• Use <down/up arrow key> to select the Set Params to Default menu
• Press <OK control key>
)You will enter the Set Params to Default menu
• Press <OK control key>
• The "Completed" message will appear after several seconds
• Press <Back control key>
Set Params to Default
Back
Ok
Set Params to Default?
Continue
IMPORTANT NOTE
Resetting (Set Params to Default) resets the selected lubrication system.
11.8 Resetting to condition on delivery
IMPORTANT NOTE
Resetting to the condition on delivery deletes all entries and values that have been set!
EN
152
To Next Page
Loading...
Need help?
General
