What to do if there is an electronics communication problem with my SKF TIH 220m?
If your SKF Heater displays signs of an electronics communication problem, try switching it OFF and then back ON. If the problem persists, it is recommended to return the TIH to SKF for repair.
How to fix an overheated coil on an SKF TIH 220m?
If the coil of your SKF Heater is overheated, allow it to cool down. Then, switch the heater OFF and then back ON.
What to do if the temperature increase is less than 1°C every 15 seconds on my SKF Heater?
If the temperature increase of your SKF Heater is less than 1°C (1.8°F) every 15 seconds (or every 30 seconds), first check the temperature probe connection. If the connection is OK, select the 30 second interval or operate the heater in TIME MODE.
What to do if the temperature probe is not connected on my SKF Heater?
If the temperature probe is not connected or defective, or there is an excessive temperature drop on your SKF Heater, check the temperature probe.
Explains the transformer-like principle of induction heating used by the TIH 220m.
Details how to set and use the temperature control mode, including probe placement and adjustments.
Explains how to set and use the time control mode for heating operations.
Provides guidelines on selecting the appropriate power level for different bearing types and conditions.
General| Item Category | Heater |
|---|---|
| Brand | SKF |
| Model | TIH 220m |
| Workpiece Weight Max. | 220 kg |
| Bearing Weight Max. | 220 kg |
| Heating Power | 2.2 kW |
| Voltage | 230 V |
| Temperature Range | 50 - 200 °C |
| Smallest Bore Diameter | 20 mm |
| Automatic Overheat Protection | Yes |
| Temperature Control | Yes |
| Time Control | Yes |
| Power | 2.2 kW |
| Heating element | Induction |
| Protection class | IP 54 |
To Next Page
