13
SKF TKTI 21 & 31
Figure 11 Areas and settings box
Colour Palette
• Pressing the left or right buttons of the navigation pad will scroll through the
available colour palettes, displaying their name above the palette.
• The selected palette will become active after about 3 seconds and will be set as the
default palette when the camera is switched on.
Figure 12 Changing the colour palette Figure 13 Level/Span
Level/Span values
• Pressing the left or right buttons of the navigation pad will reduce or increase the
Span and pressing the up or down buttons of the navigation pad will reduce or
increase the Level.
• If the unit is in Automatic mode, modifying any of these parameters will switch the
span/level to Manual mode.
2) The second function performed by the A button is to force an internal
calibration cycle.
This is performed by pressing and holding the A button for at least 5 seconds until
the calibration clicking noise is heard. The camera will make an automatic correction
to get the most accurate thermal measurement.
Note:
Use the A button to refresh the image when the image quality is not optimum.
To Next Page
Loading...
Need help?
General
