8
HOW TO START
Never attempt to start the engine unless the throttle returns to its
normal or idle position. Verify this before starting. Keep hands off of
throttle when actually starting.
• Connect tether cord and attach it to your clothing.
• If the vehicle is so equipped, verify position of the gear change
lever.
• Turn the ignition key to the ON position.
• Engage choke or press the primer only if the engine is cold.
• Turn key or pull starter handle.
• Allow engine to warm before operating at full throttle.
While the engine is warming, check the headlight, high and low
beams; taillight and brake light; then press the emergency switch to
be certain it will stop the engine. Before restarting your snowmobile,
recheck the throttle control and be sure the vehicle is headed away
from people or objects. Now re-start your engine again.
CAUTION: Make sure parking brake is fully disengaged before
operating the snowmobile. Otherwise, brake system may over-
heat leading to sudden loss of brakes and/or fire.
HOW TO STOP
Before riding your snowmobile, you should understand how to stop
it. This is done by releasing the throttle and gradually depressing the
brake lever on the left side of the handlebar and then turning the
ignition key to the “off” position. In an emergency, you may stop your
vehicle by pressing the emergency stop switch located near the
throttle control and applying the brake. Remember, a snowmobile
cannot “stop on a dime”. Braking characteristics vary with deep
snow, packed snow or ice. If the track is locked during hard braking,
skidding may result.
MDD2002-001a.FM Page 8 Wednesday, January 3, 2001 9:39 AM
To Next Page
Loading...
Need help?
General
