101
PRE-OPERATION CHECK
• Remove snow and ice from body including seat, footrests, lights,
controls and instruments.
• Verify that track and idler wheels are unfrozen and free to turn.
• Activate the brake control lever and make sure the brake fully ap-
plies before the brake control lever touches the handlebar grip. It
must fully return when released.
• Check the parking device. Apply parking brake and check if it op-
erates properly.
• Activate the throttle control lever several times to check that it
operates easily and smoothly.
WARNING
The pre-operation check is very important prior to operating
the vehicle. Always check the proper operation of critical con-
trols, safety features and mechanical components before start-
ing. If not done as specified here, severe injury or death might
occur.
WARNING
Always use a wide-base snowmobile mechanical stand to
properly support vehicle during any track verification. Slowly
accelerate engine in order to rotate track at very low speed
when it is not on ground.
Mmo2003-003a.book Page 101 Tuesday, March 19, 2002 2:22 PM
To Next Page
Loading...
