Cooling
System
Check condition
of
hoses and tightness
of
clamps. Using a hydrometer check
that antifreeze solution
is
adequate for
the temperatures at which the vehicle
will
be
operated.
0
NOTE: If coolant temperature
rises
above recommended range
of
50
to 100°C (120 to 212°F), hose off grime
from the heat exchanger (underneath
the frame above the track).
Headlamp
Beam
Aiming
To
adjust,
remove
the four adjusting
s~rew
(4) caps and turn upper or lower adjust-
ing screws to obtain desired beam posi-
tion.
A007
004
002
screw
Replace adjusting screw caps after ad-
justment.
Bulb
Replacement
If the headlamp bulb
is
burnt, open hood
and unplug the connector from the head-
lamp. Remove the rubber boot and un-
fasten bulb retainer clips. Detach the
bulb and replace.
Installation
is
the
reverse
of
removal pro-
cedure.
40
---------------------------
,.,
CAUTION: Never touch
gl~ss
por-
T tion of
an
halogen bulb With bare
fingers, it shortens it's operating I
if~.
If by mistake glass
is
touched clean
1t
with
a glass cleaner
that
will not leave
a film
on
the bulb.
A002
004 009
Retainer clips
If taillight bulb
is
burnt, unfasten the two
(2) screws holding the lens and remove.
Replace bulb and install lens. Do not
over tighten lens retaining screws .
.A.. WARNING: Always check light
T operation after
bulb
replacement.
General
Inspection
Check the electrical wiring and
com-
ponents, retighten loose
connectio~s.
Check for stripped wires or damaged
In-
sulation. Thoroughly inspect the vehi-
cle and tighten loose bolts, nuts and
iinkage. Inspect skis and ski runners for
wear.
To Next Page
Loading...
