-13-
..0>>:=40>
1 ,9 0C?09>4:9 .:=/ 4>
9
0.0>>,=D , .:=/ B4?3
,/0<@,?0>4E0 .:9/@.?:=> ?3,? 4> .,;,-70
:1.,==D492?30.@==09?90.0>>,=D1:=D:@=
?::7 8@>? -0 @>0/ This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
!%The smaller the gauge number, the
heav i er the cord.
#
! $+$!)% $! !#$
'!%%# % &## %%!!$
!
WARNING
%
::7H>
8;0=0
#,?492
:=/$4E049(
(
4=0$4E0>4988
3
-6
6-8
8
-10
10-12
12-16
1
8 16 16 14 0.75 0.75 1.5 2.5
18 16 14 12 0.75 1.0 2.5 4.0
18 16 14 12 0.75 1.0 2.5 4.0
1
6 16 14 12 1.0 2.5 4.0 —
14 12 —— ————
25 50 100 150 15 30 60 120
:=/092?34900? :=/092?3490?0=>
%=:@-70$3::?492
Read instruction manual first! Always lock trigger in the center “OFF” position
before making adjustments or assembling accessories.
%#!&%!!( !%$%#%
"#! 1. Battery not charged.
2. Battery temperature is too hot or cold for operation.
3. Burned out switch.
#* 1. If equipped, check battery charge condition lights for charge status.
Charge battery if needed.
2. Let battery sit a few minutes or until it reaches normal operating
temperature.
3. Have switch replaced by an Authorized Skil Service Center or Service Station.
%#!&%%#*( !%#
"#! 1. Charger not plugged into outlet.
2. Charger’s connector pin not completely inserted into tool.
#* 1. Confirm charger is plugged into outlet.
2. Confirm charger’s connector pin is completely inserted into tool.
!
WARNING
BM 1619X03886 07-09:BM 1619X03886 07-09 7/23/09 10:54 AM Page 13
To Next Page
Loading...
