Skil 3320 - Troubleshooting (continued); Saw Will Not Start Issues; Blade Not Reaching Full Speed Issues

42
Warning! Turn switch “off” and always remove plug from the
power source before trouble shooting.
Saw will not start
PROBLEM
1. Power cord is not plugged in.
2.
Fuse or circuit breaker tripped.
3. Cord damaged.
4.
Burned out switch.
REMEDY
1.
Plug saw in.
2.
Replace fuse or reset tripped circuit
breaker.
3.
Have cord replaced by an Authorized Skil
Service Center or Service Station.
4.
Have switch replaced by an Authorized Skil
Service Center or Service Station.
Blade does not come up to speed
PROBLEM
1.
Extension cord too light or too long.
2.
Low house voltage.
REMEDY
1.
Replace with adequate cord.
2.
Contact your electric company.
2091_Manual_SKIL_3320.indd 422091_Manual_SKIL_3320.indd 42 10.02.10 16:30:0610.02.10 16:30:06