-19-
&>;A.81%4;;@5:3
Read instruction manual first! Remove battery pack from the tool before making
adjustments or assembling accessories.
&$"'&"")!"&%&$&
#$" 1. Battery pack not charged.
2. Battery pack not installed properly.
3. Battery pack temperature is too hot or cold for operation.
4. Burned out switch.
$ + 1. If equipped, check battery charge condition lights for charge status,
charge battery if needed.
2. Confirm battery is locked and secured to the tool.
3. Let battery sit a few minutes or until it reaches normal operating
temperature.
4. Have switch replaced by an Authorized Skil Service Center or Service Station.
&$"'&&$+#)!"&$
#$" 1. Charger not plugged into outlet.
2. Battery pack not completely inserted into charger.
$ + 1. Confirm charger is plugged into outlet.
2. Confirm battery pack is inserted into charger completely.
&$"'*%%(($&"!
#$" 1. Blade is bent.
2. Blade not secure in blade holder.
$ + 1. Discard blade and use different blade.
2. See Assembly section, “Installing a blade” (page 9)
&$"''&!%%&% "&"$"$%)!'&&!
#$" 1. Dull blade with improper tooth set.
2.Tip of blade strikes workpiece or inside of pipe.
$ + 1. Discard blade and use a different blade.
2. Do not strike tip of blade while cutting and make sure that blade is long
enough to cut through a pipe.
!
WARNING
SM 1619X04463 05-09:SM 1619X04463 05-09 5/29/09 3:22 PM Page 19
To Next Page
Loading...
