To Next PageTo Next Page
Need help?Do you have a question about the Skil 5350 and is the answer not in the manual?
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
Power tool plugs must match the outlet. Never modify the plug in any way.
Stay alert, watch what you are doing and use common sense when operating a power tool.
Do not force the power tool. Use the correct power tool for your application.
Have your power tool serviced by a qualified repair person using only identical replacement parts.
Keep hands away from cutting area and the blade. If both hands are holding the saw, they can not be cut by the blade.
Kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing an uncontrolled saw to lift up and out of the workpiece toward the operator.
Check guard for proper closing before each use. Do not operate the saw if guard does not move freely.
This tool is not intended for use by children and persons with reduced physical, sensory or mental capabilities.
SKIL can assure flawless functioning of the tool only when original accessories are used.
Always check that the supply voltage is the same as the voltage indicated on the nameplate of the tool.
The noise level when working can exceed 85 dB(A); wear ear protection.
When you put away the tool, switch off the motor and ensure that all moving parts have come to a complete standstill.
Do not connect the blue (= neutral) or brown (= live) wire in the cord of this tool to the earth terminal of the plug.
Switch on tool by first pressing knob A forward and then pulling trigger switch B.
Disconnect the plug from the power source and/or remove the battery pack, if detachable.
Tilt tool forward with line-of-cut indicator R lined up with desired line of cut marked on the workpiece.
For making exact cuts along a workpiece edge. Can be inserted in either side of foot.
Only use sharp saw blades of the correct type.
This tool is not intended for professional use. Always keep tool and cord clean.
General
