-16-
%=:@-70$3::?492
Read instruction manual first! Remove battery pack from the tool before making
adjustments or assembling accessories.
%#!&%!!( !%$%#%
"#! 1. Battery pack not charged.
2. Battery pack not installed properly.
3. Battery pack temperature is too hot or cold for operation.
4. Burned out switch.
#* 1. Check battery charge condition lights for charge status,
charge battery if needed.
2. Confirm battery is locked and secured to the tool.
3. Let battery sit a few minutes or until it reaches normal operating
temperature.
4. Have switch replaced by an Authorized Skil Service Center or Service Station.
%#!&%%#*"( !%#
"#! 1. Charger not plugged into outlet.
2. Battery pack not completely inserted into charger.
#* 1. Confirm charger is plugged into outlet.
2. Confirm battery pack is inserted into charger completely.
%#!&)$$''#%!
"#! 1. Blade is bent.
2. Blade not secure in blade holder.
#* 1. Discard blade and use different blade.
2. See Assembly section, “Installing a blade” (page 9)
%#!&&% $$%$!%!#!#$( &%%
"#! 1. Dull blade with improper tooth set.
2.Tip of blade strikes workpiece or inside of pipe.
#* 1. Discard blade and use a different blade.
2. Do not strike tip of blade while cutting and make sure that blade is long
enough to cut through a pipe.
!
WARNING
SM 1619X03849 11-08:SM 1619X03849 11-08 11/21/08 10:21 AM Page 16
To Next Page