16
OPERATING INSTRUCTIONS
WARNING
To reduce the risk of re, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack, or charger in
uid or allow a uid to ow inside them.
Corrosive or conductive uids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc, can cause a short
circuit.
WARNING
If any parts are damaged or missing, do not operate this product until
the parts are replaced.
Use of this product with damaged or missing parts
could result in serious personal injury.
WARNING
Do not attempt to modify this tool or create accessories not
recommended for use with this tool.
Any such alteration or modication
is misuse and could result in a hazardous condition leading to possible serious injury.
WARNING
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when assembling
parts, making adjustments, cleaning, or when not in use.
WARNING
Do not allow familiarity with this product to make you careless.
Remember that a careless fraction of a second is sufcient to inict serious
injury.
WARNING
Always wear eye protection with side shields marked to comply with
ANSI Z87.1, along with hearing protection.
Failure to do so could result
in objects being thrown into your eyes and other possibly serious injuries.
Before each use, inspect the entire product for damaged, missing, or loose parts, such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced.
Application
You may use this product for basic felling, limbing, pruning, and woodcutting of lumber and
trees.
Filling Oil Tank with Bar and Chain Lubricant
WARNING
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool before lling the
tank with oil.
WARNING
Do not smoke or bring any re or ame near the oil or the chain saw.
Oil may spill and cause a re.
NOTICE:
The chain saw is not lled with oil at the time of purchase. It is essential to ll the
tank with oil before use. Operating the chain
saw without chain oil or when the oil level is
below the minimum mark will result in damage
to the chain saw. Chain life and cutting capacity
depend on optimum lubrication. The chain is
automatically lubricated with chain oil during
operation.
1. Remove the battery pack from the chain
saw.
2. Clean the oil tank cap and the area around
it to ensure that no dirt falls into the oil tank.
3. Position the chain saw on its side on a
rm, at surface, so that the tank cap is
facing upwards. Rotate the oil tank cap
counterclockwise to remove it (Fig. 8).
Fig. 8
To Next Page
Loading...
Need help?
General
