STEP 6–ATTACHING THE FRAME STAND TO THE FRAME
Lay the frame with attached net down on the ground, bungee
knobs touching the ground, and place the frame stand down
around the bottom of the frame.
Slide the bolt through the frame
stand and slide 2 black washers onto
the bolt, then slide the bolt into the
frame. Slide one silver washer onto
the bolt. Tighten the bolt with a nut
and wrench. Make sure the nut is on
the inside of the frame. Repeat on
other side.
STEP 7–CONNECT ADJUSTMENT ARM TO FRAME
Clip the adjustment arm onto the
middle of the frame stand in between
the grips. Stand the Crazy Catch up
and clip the other end of the adjust-
ment arm to the top of the Crazy
Catch frame. Make sure the bungee
knobs point towards the back of your
Crazy Catch. Your Crazy Catch is now
set up and ready for use.
STEP 8–ADJUSTING THE ANGLE
OF THE CRAZY CATCH
Simply loosen the knob on the angle adjuster and move the poles further
apart or closer together depending on what angle you want. Tighten the
knob when you have reached your desired angle.
STEP 9–STORAGE
There is no need to dismantle the Crazy Catch once you have put it together.
Simply fold up by uncliping the angle adjuster from the frame and sliding it
into the net.
Crazy Catch has been manufactured to deliver a high level of performance
over time. To extend the life of the Crazy Catch it is recommended that it be
stored indoors when not in use. Do not expose the net to sharp objects.
STEP 10–BUNGEE REPLACEMENT
If you need to replace or remove the bungees, hold the knob when unlooping the bungee. For
replacement bungees please visit SKLZ.com or call our toll free number: 877-225-7275.
TOLL FREE: 877-225-7275
To Next Page
Loading...
