Starting at the top of the frame, grasp one of the middle bungees by the knob. Pull the knob over
the frame (4a) and wrap it under so it loops the frame (4b). Pull the knob through the bungee to
secure on the frame (4c). While holding the net, slide the rubber tube up towards the knob (4d).
Repeat on the middle bungees on the other three sides. Once complete; start at a corner and
connect each corner bungee. Once you have the corners and the middle bungees connected,
connect the remaining bungees to the frame.
STEP 5–TIGHTENING THE NET
All of your bungees should be connected and facing up, as pictured.
NOTE: Bungees should be tightened based on the same
pattern you used to attach them in STEP 4. Perform this
step carefully as tightening the bungees creates very high tension.
Slide the pointed end of the Crazy Catch Net Tool into the part of the bungee looped around the
net (5a). Pull the bungee loop toward the knob (5b). Pull the bungee over the knob and rest the
Crazy Catch tool on the other side of the frame to help steady the bungee and tool (5c).
Holding the tension of the bungee with the net tool against the frame, use your fingers to slip the
bungee under the knob to secure (5d), and then slide the tool out (5e). Once finished, your bungee
and knob should resemble image 5f. Make sure the bungee is secure under the knob. Repeat on
the remaining bungees. Make sure that the bungees in the corners fall into the groves of the frame;
slide them over and into the grooves if they are not there already.
4a 4b 4c 4d
5a-Close-up5a 5b 5c
5d 5e 5f
Top
2
3
4
5
6
78
WRONG
RIGHT
SKLZ.com
To Next Page
Loading...
