Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Note
The small diameter of the single cable seal must point to the
socket housing.
– Slide single cable seal -A- with the correct assembly tool -B-
into the socket housing -arrow- ⇒ o3.3 f single cable seals”,
page 85 .
– Shorten the repair wire and single cable of the vehicle's
wiring loom as required with the wire stripper -VAS 1978/3-.
– Strip the ends of the repair wire and the vehicle's single
cable by 6-7 mm with the wire stripper.
– Crimp the stripped ends of the repair wire and single cable
of the vehicle's wiring loom with the crimping pliers and a
crimp connector, as described in section ⇒ b2.9 reak with
single repair point”, page 66 .
Citigo 2012 ➤, Citigo-e iV 2020 ➤, Enyaq 2021 ➤, Enyaq Coupe 2021 ➤, Fabia 2000 ...
Electrical System - general notes - Edition 12.2021
84 Rep. gr.97 - Wiring