Seats and Stowage70
– Release the lever and push the seat further until the lock
is heard to engage.
Adjusting height of seat
– Lift the seat if required by pulling or pumping lever
⇒ page 69, fig. 51 upwards.
– Lower the seat if required by pushing or pumping lever
downwards.
Adjusting angle of backrest
– Move forward away from the backrest (do not lean against it).
– Turn the handwheel in order to adjust the angle of the
backrest accordingly.
Adjusting lumbar support*
– Turn the handwheel until you have set the most comfort-
able curvature of the seat upholstery in the area of your spine.
Adjusting front seats electrically*
Adjusting seats
Adjusting seat
– Adopt the correct seated position ⇒ page 69.
– Press switch or ⇒ fig. 52 in the direction of the desired
setting.
– Turn the handwheel until you have set the most comfort-
able curvature of the seat upholstery in the area of your spine.
Switch is operated in order to move the seat up/down and
forward/back, while switch is operated in order to move the backrest
forward or back.
You can adjust the lumbar support only mechanically with the handwheel
.
WARNING
• Only adjust the driver seat when the vehicle is stationary - risk
of injury!
• Take care when adjusting the seat! Adjusting the seat without
care can lead to bruises or injuries.
• The backrests must not be angled too far back when driving
otherwise this will affect proper operation of the seat belts and of
the airbag system - risk of injury!
1
2
2
3
4
Fig. 52 Side view:
controls for adjusting
seat
A
B
C
A
B
C