What does the 'I_t-trP' error mean on my Skov BF 50 LPC-3?
The 'I_t-trP' error on your Skov Fan means the motor has experienced thermal overload (I2t). This appears after the motor delivers > 100% of the value in settings for a period of time to prevent damage.
What does 'dAtA-F' error mean on my Skov BF 50 LPC-3?
If you see 'dAtA-F' error on your Skov Fan, it means that internal memory has an error (IO). Press the stop key.
What does 'Fan-F' error mean on my Skov BF 50 LPC-3?
If you see 'Fan-F' error on your Skov Fan, it means that cooling fan has an error (IP66 only). Replace the motor controller.
What does the 'P-LOSS' error mean on my Skov BF 50 LPC-3 Fan?
The 'P-LOSS' error on your Skov Fan indicates a phase error. Measure the supply phases.
What does the 'Flt-dc' error mean on my Skov BF 50 LPC-3?
The 'Flt-dc' error on your Skov Fan indicates that the ripple voltage is too high. Measure the supply phases.
What does the 'th-Flt' error mean on my Skov BF 50 LPC-3?
The 'th-Flt' error indicates a defective thermistor on the heat sink of your Skov Fan. Replace the motor controller.
What does the 'U-t' error mean on my Skov BF 50 LPC-3 Fan?
The 'U-t' error on your Skov Fan indicates that the motor controller's temperature is below the minimum limit; the temperature must be increased.
What does the 'O-volt' error mean on my Skov BF 50 LPC-3 Fan?
The 'O-volt' error on your Skov Fan indicates over voltage on the DC bus. Verify that the supply voltage is within the allowed tolerance.
What does the 'Out-F' error mean on my Skov Fan?
The 'Out-F' error on your Skov Fan indicates an output error. Check the motor connections.
Why is my Skov Fan making abnormal noises?
Abnormal noise from the Skov Fan can stem from faulty mounting. Inspect the setup as per the documentation, and retighten if necessary. Alternatively, the noise might be due to bearing issues, in which case the motor should be replaced. Another cause is a vibrating fan; inspect the fan blades for defects, correct assembly, or dirt. Replace or clean as needed.
General| Type | Axial fan |
|---|---|
| Impeller diameter | 500 mm |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Speed | 1350 RPM |
| Noise level | 65 dB(A) |
| Weight | 12 kg |
| Motor type | AC |
To Next Page
