SKY-WATCHER 13065EQ2 - Finderscope Assembly; Eyepiece Assembly

TELESCOPE
ASSEMBLY
FINDERSCOPE
A ASSEMBLY
EYEPIECE
A ASSEMBLY
4
ATTACHING THE TUBE RINGS TO MOUNT(5)
1) Remove the telescope tube from its plastic packaging.
2) Remove the tube rings from telescope by releasing
their thumb nuts and opening their hinges.
3) Using the bolts provided, fasten the tube rings to
the mount with the 10mm wench provided.
ATTACHING THE TELESCOPE MAIN TUBE TO
TUBE RINGS (6)
1) Remove the telescope tube from the paper covering.
2) Find the center of balance of the telescope tube. Place this in
between the two tube rings. Close the hinges around the
telescope and fasten securely by tightening the thumb nuts.
5.
6.
ATTACHING THE FINDERSCOPE BRACKET (7)
1) Locate finderscope optical assembly.
2) Slide finderscope bracket into the rectancular slot
and tightened screw to hold mount in place.
7.
INSERTING EYEPIECE
(8), (9)
1) Unscrew the thumbscrews on the end of the
focus tube to remove the black plastic end-cap.
2) Re-tighten thumb screws to hold
eyepieces in place.
9.
8.