Get the most from Sky±HD
15
Important information about Single Satellite Feed installations
Do you have a Single Satellite Feed like this?
After installation of your Sky±HD box you may see some incomplete
information or error messages on screen. Don’t worry, it’s easy to fix —
just follow these instructions to switch the Single Feed Mode to ON.
Switching the Single Feed Mode to ‘ON’
1 First, ensure that the satellite feed is connected to Dish Input 1 on
the back of your set top box.
2 Press services on your remote to highlight options in the Top
Menu, then the right arrow once so that Settings is highlighted.
3 Now press select to highlight the Picture tab.
4 Press 0, 1, select in quick succession to enter the Installer menu.
5 The Setup tab will then be highlighted within the Installer menu.
Press down to highlight Single Feed Mode within the menu.
6 Press the right arrow once to turn Single Feed Mode to ‘ON’.
7 Press the
green button to Save Settings and the Single Feed
Mode Caution message will be displayed.
8 Your Sky±HD box is now ready to be rebooted. When this happens:
a. Any current recordings will be stopped
b. On Demand Showcase will be disabled
c. Auto Standby will be enabled
To reboot your box, press select, but please allow a little time for this
to happen.
TV
SAT
FM-DAB
76
To Next Page
Loading...
