A: T10 send binding signal with ID to bind a new receiver. Once blinded the new one, old receiver need to rebind afterwards.
Q: what is the definition of the sound buzzer?
A: 3 short beep-power on. 4 short beep- binding succeeded, continues short beep-battery low level; slow continues beep-
receiver not turn on or disconnected.
Maintenance, Servicing
Storage for not using certain period
Put T10 a dry and ventilated area. No direct Sun light to prevent harm to the internal Lipo battery. If store it over three
months, it is highly recommended to put room temperature between 22C to 28C. DO NOT put it below 20C or higher than 4SC
area.
Transportation, Storage
WARNING
In order to prevent lost or getting hurt, Please strictly follow the rules of operation: Keep small parts or wire away from children
can reach. DO NOT let children touch the small parts of T10.
ATTENTION:
1. DO NOT put T10 into water. If it does, please switch of the power and dry it.
2. DO NOT crash the T10 or break the battery is prohibited.
Scan the QR code to download the APP
If download failed, search www.skydroid.xin
Device Helper Skydroid FPV Skydroid Tower
devicehelper.apk
skydroidfpv.apk
skydroidtower.apk
Device Helper-in use of adjustment of radio parameter, firmware upgrade, save models, mode change, etc.
Skydroid FPV-in use of linking Skydroid video, foating window can be top of others App(need to turn on foating window feature
in Android system), use for VR, Video capture and Data rate adjustment).
Skydroid Tower-optimised by tower 4.0, can connect to mavlink protocol of APM, PX4 fight controller to realise waypoint data
telemetry. Also has video serial port (similar to OJI go).
ATTENTION:
You need to wire connect with the Skydroid FPV to open the foating window. Activate QGC and connect with bluetooth to start
telemetry. In the future, when QGC join Skydroid SOK then the operation will be as simple as Skydroid Tower. No need to
connect bluetooth and no need to multiply another APP on QGC. Very simple. Highly recommend to use Skydroid tower.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment of and on, the user is encouraged to try to correct the interference by one or
more of the following.
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit diferent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
To Next Page
Loading...