SJ 46A & SJ 46AJ
December 2007 Page 23
Section 2 - Operation Special Options
2.6-4 Tire Sealant (If Equipped)
This option is identified with a tire sealant label located
at the rim of the wheel.
1
2
Figure 2-9. Tire Sealant Label
Tire Sealant Label - This label indicates that tire sealant
is present inside the tires.
Tire Valve Stem Cap1. - This green valve stem cap
is substituted onto air tires to indicate sealant has
been installed.
Sealant2. - This symbol signifies that the tire is
equipped with sealant.
WARNING
The operator MUST properly handle tires
with sealant.
When depressurizing, inflating or •
checking tire pressure, ensure that
the valve stem is at the top to prevent
sealant from entering the stem (refer
to Figure 2-9).
If the tire no longer holds pressure, •
replace the tire.
WARNING
The sealant contains propylene glycol.
Do not ingest, inhale or get into eyes. If
it gets into your eyes, flush with water for
15 minutes. Consult physician.
3.6-5 Hydraulic Generator (If Equipped)
To start the hydraulic generator:
1. Ensure that engine is running.
2. On platform control console, turn generator on/
off switch to “
” on position.
To restore normal operation:
1. On platform control console, turn generator on/
off switch to “
” off position.
NOTE
An engine shut down will turn the generator
off. Normal boom functions are disabled
while the generator is on.
To Next Page
Loading...
Need help?
General
