Page 56 December 2007
SJ 46A & SJ 46AJ
Chassis Tilt Section 2 - Operation
2.15 Chassis Tilt
This section guides the operator with regard to
recovering from an inclined position.
IMPORTANT
When the boom is raised or extended, the
aerial platform must only be operated on
firm level surfaces.
WARNING
When the aerial platform becomes tilted
causing the alarm to sound, the platform
must be fully lowered and retracted
immediately. Drive functions are not
available when the tilt alarm is active.
2.15-1 Platform Uphill
If the aerial platform becomes tilted with the platform
uphill (refer to Figure 2-15) follow the steps below to
return to a lowered and retracted position.
1. Lower main boom completely.
2. Lower riser completely.
3. Retract fly boom completely.
4. Drive to a firm level surface.
2.15-2 Platform Downhill
If the aerial platform becomes tilted with the platform
downhill (refer to Figure 2-16) follow the steps below to
return to a lowered and retracted position.
1. Retract fly boom completely.
2. Lower riser completely.
3. Lower main boom completely.
4. Drive to a firm level surface.
Figure 2-16. Platform DownhillFigure 2-15. Platform Uphill
To Next Page
Loading...
Need help?
General
