Skyjack SJ 46AJ User Manual

SJ 46A & SJ 46AJ
December 2007 Page 37
TM
Section 2 - Operation Function Tests
7. Select “ ” start position from engine
start/on/off switch to start engine.
8. Dismount from platform.
9. On base control console, attempt to
activate each boom and platform switch
while holding function enable switch.
Result: All boom and platform functions
should not operate while holding function
enable switch.
10. Push in “
” emergency stop button to
turn engine off.
11. Pull out “
” emergency stop button.
2.9-3 Platform Control Console
WARNING
Ensure that you maintain three points of
contact to mount/dismount platform.
1. Enter platform and close gate.
WARNING
DO NOT operate any control on platform
control console without proper fall
protection secured to designated location
in platform. Failure to avoid this hazard
could result in death or serious injury!
WARNING
Ensure that there are no personnel or
obstructions in test area and that there is
sufficient room for boom to swing.
Test Platform Emergency Stop Light•
1. On platform control console, pull out “
”
emergency stop button.
Result: Emergency stop light should
continuously illuminate.
Emergency Stop
Tie-off Point
Platform Railing
Manual Box
Drive/Steer Controller
Tie-off Point
Footswitch
Platform Control
Console
Platform
Assembly
Footswitch
Platform
Assembly

Skyjack SJ 46AJ Specifications

General

Brand	Skyjack
Model	SJ 46AJ
Category	Boom Lifts
Language	English