SECTION 1, Page 2
SJKB Battery Powered
Figure 1-1. Front Panel Labels
General Work Conditions
Read and pay attention to all labels on the unit.
DO NOT exert excessive side forces on platform while
elevated.
DO NOT overload, the lift relief valve does not protect
against overloading when the platform is elevated.
DO NOT alter or disable limit switches or other safety
devices.
DO NOT raise your platform in windy or gusty
conditions.
DO NOT exceed the rated capacity of your unit. Make
sure the load is evenly distributed on the platform.
Jobsite Hazards
DO NOT
operate the unit on surfaces not capable of
supporting the weight of the work platform, including the
rated load, e.g. covers, drains and trenches.
BE AWARE of overhead obstacles, especially
electrical lines. Also be aware of poorly lit areas that
might hide overhead obstacles.
DO NOT elevate the work platform if the unit is not on
firm level surfaces. Avoid pot holes, loading docks,
debris, drop offs and surfaces that my affect the stability
of your work platform.
DO NOT climb or descend a grade steeper than 30%
while in travel mode. Boom elevated driving must be
done only on firm surfaces. (Ref. Table 1-1)
ENSURE that there is no person(s) in the path of
travel.
Work Platform Conditions
An operator should not use any work platform that:
Has ladders, scaffolding or other devices mounted on it
to increase its size or work height.
Does not have a clean, uncluttered work area.
Does not appear to be working properly.
Has been damaged or appears to have worn or missing
parts.
Has alterations or modifications not approved by the
manufacturer.
Has safety devices which have been altered or disabled.
SECTION 2, Page 13
SJKB Battery Powered
Proper operation of the parking brakes should be checked daily or at the beginning of each shift. Locate the machine
in an appropriate area for testing the brakes. IMPORTANT NOTE: The area for testing the machine MUST be
completely level and free of obstructions. DO NOT drive on an incline unless the parking brakes are working properly.
With the machine fully stowed and the throttle switch in the high position (if engine powered). Drive the machine
forward at full speed and remove foot from foot switch. Repeat this step driving in reverse.
WARNING
Parking brakes will instantly engage causing the machine to stop immediately.
The machine should come to an instant and abrupt stop. If the machine does not stop instantly or if the machine pulls
to one side while stopping, the brake adjustment MUST be checked before putting the machine into service.
Table 2-3. Tire Specifications - SJKB-33N
Table 2-4. Maximum Platform Capacities
Model Platform Capacity (unrestricted)
ALL MODELS
500# (227kg) 2 occupants
NOTE: Refer to capacity label on work platform for additional information.
RECOMMENDED HYDRAULIC OILS
DO NOT use synthetic or fire resistant oil in this work platform. Use ATF Dexron III (ESSO) or equivalent hydraulic oil.
For conditions causing oil temperatures below -31°F (-35° C) and above 122°F (50° C) consult Skyjack, Inc.
Table 2-2. Owner’s Annual Inspection Record
MT33N203
MT33N204
MT33N205
MODEL NUMBER__________________________ SERIAL NUMBER______________
RECORDING
DATE
RECORDING
YEAR #
12345678
OWNERS
NAME
INSPECTED
BY
BRAKE OPERATION TEST PROCEDURE
Model
Tire
Fill SpecificationSize Rating
SJKB-33N
27.5 x 7.5 x 15 14 Ply Solid Urethane†
NON-MARKING(Option)
27.5 x 7.5 x 15 Solid
† - Solid urethane used for filling MUST be 75 durometer.
To Next Page
Loading...
