SKYLUX Climalux - Glazing

01/05/2020
41/56
E_MH_Mounting_instructions_Skylux_Climalux
Climacrown
The option Climacrown is a cornice that is mounted around the Climalux roof. If this option is provided, then the
Climacrown must be mounted before the glazing is installed on the roof.
See mounting instructions Climacrown (art 48477).
Glazing: plastic sheets
Preparation
The maximum thickness of the plastic sheets is 16 mm or 32 mm. Only the left and/or the right sheet are cut
to size. Take into account a lateral clearance of 5 mm on each side (page 25). Ensure each sheet has an end
profile on the gutter side. Check whether the end profile is perforated at the bottom. This is required for proper
water drainage. Ensure that the UV protected side of the sheet is always upwards. All useful information for the
processing and installation of glazing plastics can be found on page 13 & 14.
Apply a silicone sealant that does not aect plastic
material at the upper edge of the end profile. Ensure
that the multiple-walled plastic sheets have sucient
slope to be able to appeal to the guarantee.
Glazing: glass sheets
Preparation
The maximum thickness of the glass sheets is 10 mm. Always use laminated glazing (44.2 or 55.2) in your
conservatory roof according to the applicable standards. Consult your glass supplier.
Stick a L-shaped end profile L432 on the crosscut side of the glass. Use silicone SG20.
Glazing connection
When the glazing (plastic sheets or glass) consists of multiple parts, the parts can be connected using glass
connection profiles. Specific installation instructions can be requested.
L432
max.
16 mm
30
40
L432