Skytech: 5320
REV. 7-25-18 Page 10
TROUBLE SHOOTING
Should you encounter problems with your replace system, the problem may be with the replace itself or it could be with
the SKYTECH remote control. Review the replace manufacturer’s operation manual to make sure all connections are
properly made. Then check the operation of the SKYTECH remote in the following manner:
1. Be sure the transmitter’s batteries are properly installed and that the battery output is 5.0-volts or more.
2. Check to see if the receiver is connected to a 110-120 VAC power source.
3. Check to make sure the transmitter is communicating with the receiver.
• If the receiver beeps when the MODE button is depressed on the transmitter they are communicating.
• If the receiver does not beep when the MODE/SET button is depressed on the transmitter, you will need to teach
the receiver the code of the transmitter. PRESS AND RELEASE the LEARN button on the receiver and depress the
MODE/SET button on the transmitter. A change in the beeping pattern, at the receiver indicates the transmitter’s code
has been programmed into the receiver.
4. Make sure the transmitter is within the 15 to 20-feet range of the receiver.
5. Positioning of the receiver is important. If the receiver is “enclosed” in a metal surround, the operation of the receiver
may be affected as noted below. Reposition the receiver to improve operating range. It is suggested that a heat shield be
installed to protect the receiver from extreme heat. If the receiver is “enclosed” in a metal surround, this can:
• Cause the RF signal to get lost and not communicate with the receiver.
• Cause the working distance to be shorter than normal.
NOTE: A receiver located in an area, where the ambient temperature inside the case exceeds 130°F, will cause
THERMO-SAFETY feature to cut in, requiring you to reposition the receiver to stop the warning beeps, and to “reset” the
receiver’s operation.
SPECIFICATIONS
BATTERIES: Transmitter 6V- 4 ea. AAA 1.5V, Alkaline
Remote Receiver 110-120 VAC FCC ID No.’s: transmitter – K9L5001;
Operating Frequency: 303.8MHZ Canadian IC ID No.’s: transmitter –2439A-5001;
FOR TECHNICAL SERVICE, CALL:
U.S. INQUIRIES CANADIAN INQUIRIES
(855) 498-8324 or (260) 459-1703 (877) 472-3923
Sales Support: (855) 699-6167
Website: www.skytechpg.com
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY
TO OPERATE THE EQUIPMENT.
To Next Page
Loading...
Need help?
General
