EasyManua.ls Logo

Skytech TS-3 User Manual

Skytech TS-3
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Skytech: TS-3 Wired Thermostat
REV. 8-30-17 Page 1
INSTALLATION AND OPERATING INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS
DO NOT ATTEMPT TO INSTALL OR OPERATE
Model: TS-3
INTRODUCTION
This TS-3 wired wall thermostat was developed to provide a safe, reliable control system for gas heating appliances. The
system can be operated thermostatically or manually from the wall unit.
WALL MOUNT THERMOSTAT
The TS-3 wired thermostat operates on (2) 3V Button Cell (Included) which
powers the LCD screen and circuit board. Before using the TS-3 wall
thermostat the 3V batteries must be installed into the battery
compartments.
It is recommended that CR2032 lithium batteries always be used for
longer battery life and maximum operational performance. If the LCD screen
will not come on, check the 3V Button Cell battery.
ROOM
TEMP
THERMO
MODE
“SET
ON
SET
OFF
LCD
DISPLAY
ON/UP
BUTTON
OFF/DOWN
BUTTON
SET
BUTTON
TO INSTALL BATTERIES IN THE THERMOSTAT (TS-3)
1. Remove face from backing wall plate this is done by sliding the face up
about 1/2” then pull the face off the base plate. As shown in Figure 1.
2. Locate the (2) holders for the 3V button cell batteries (See Figure 2).
3. Slide the button cell batteries into the battery holders. (Make sure that
the batteries are installed with the (+) plus side facing you or up.
4. Reinstall the face to the backing plate this is done by sliding the
face in and down about 1/2” then check that the (2) male terminal
connectors on the face are engaged in the female terminal connectors
on the backing plate. As show in Figure 1.
ROOM
TEMP
ON
OFF
SET
(2) 3 Volt Button
Cell Batteries
Battery
Removal
Slots
Plus
Side
+
Plus
Side
+
Figure 1 Figure 2
Question and Answer IconNeed help?

Do you have a question about the Skytech TS-3 and is the answer not in the manual?

Skytech TS-3 Specifications

General IconGeneral
BrandSkytech
ModelTS-3
CategoryThermostat
LanguageEnglish

Summary

Introduction to Skytech TS-3 Thermostat

Wall Mount Thermostat Operation

Install Batteries in the TS-3 Thermostat

Step-by-step instructions for inserting the 3V button cell batteries into the TS-3 thermostat.

TS-3 Thermostat Operation Details

Setting Manual Operation

Guide on how to manually control the thermostat's ON, OFF, and SET functions.

Setting Thermostat Operation

Instructions for setting the thermostat to automatically control room temperature.

Installation Instructions

Wall Mounting the TS-3 Thermostat

Detailed steps for physically mounting the TS-3 thermostat base plate and face to the wall.

General Installation Warnings

Crucial safety warnings and precautions to follow during thermostat installation.

Wiring Instructions

Wiring Millivolt Valves, Electronic Spark Ignitions, and Other Appliances

Guidance on connecting the TS-3 thermostat to various heating systems.

System Check Procedures

System Check for Millivolt Valves and Ignition Systems

Steps to verify the proper operation of the thermostat with different appliance types.

General Information and Troubleshooting

Battery Life and Replacement

Information on battery life expectancy and when to replace the thermostat batteries.

Troubleshooting Common Issues

Guidance on diagnosing and resolving problems with the thermostat and appliance system.

Product Specifications

Limited Warranty Details

Installation and Use of System Warranty

Warranty terms related to proper installation and system usage.

Repair or Replacement of System or Parts Warranty

Policy for repairing or replacing defective thermostat components under warranty.

Warranty Claims and Service Process

Procedure for submitting a valid warranty claim and contacting Skytech for service.

Related product manuals