Skytech 5320 User Manual

Skytech: 5320
REV. 7-25-18 Page 3
SETTING °F/°C SCALE
The factory setting for temperature is °F. To change this setting to °C, rst press and hold the UP button and the DOWN
button on the transmitter at the same time. Follow this same procedure to change from °C back to °F. When changing
between the °F and °C scales, the temperature in the SET frame defaults to the lowest temperature (45°F, or 6°C). The
highest SET temperature is 99° Fahrenheit (32° Celsius).
SETTING DESIRED ROOM TEMPERATURE
This remote control system can be thermostatically controlled when the transmitter
is in the THERMO mode (THERMO must be displayed on the screen). To set the
DESIRED room temperature, press the MODE/SET button to place the transmitter into
THERMO mode, then press the UP or DOWN button to select the desired room
temperature. The highest SET temperature is 99° Fahrenheit (32° Celsius).
OPERATIONAL NOTE: TO CONSERVE BATTERY POWER, CHANGES IN ROOM
TEMPERATURE ARE AUTOMATICALLY UPDATED EVERY TWO MINUTES TO THE
TRANSMITTER.
PM
ROOM
SET
TIMER
OFF
ON
THERMO
AM
SETTING THE TEMPERATURE SWING (TEMPERATURE DIFFERENTIAL)
PM
ROOM
SET
TIMER
OFF
ON
The Thermo Mode on the transmitter operates the appliance whenever the ROOM
TEMPERATURE varies a certain number of degrees from the SET TEMPERATURE.
This variation is called the “SWING” or TEMPERATURE DIFFERENTIAL.
1. To change the temperature “SWING” setting (1º- 3º), press the TIMER and DOWN
buttons simultaneously to display the current “SWING” setting in the SET TEMP
frame. The letter “S” will display in the ROOM TEMP frame on the LCD screen.
2. Press the UP or DOWN button to change the temperature differential or “SWING”
(1º- 3º).
3. To store the “swing number press the MODE/SET button or allow 15 seconds to
lapse, and the new “swing number’ will be automatically programmed.
MANUAL CHECK OF “ SWING” OR TEMPERATURE DIFFERENTIAL
The operation of the factory set “THERMO SWING” can be checked by adjusting the SET TEMP 2º F above or below the
room temperature. This will cause the system to turn ON or OFF. Normally the system will only respond to temperature
changes every two minutes. Manually changing the SET temperature will activate the system in less than 10 seconds. IF
the “SWING” is changed, then a new room temperature differential will respond. Factory setting of “SWING” temperature
is 2º F.

Skytech 5320 Specifications

General

Brand	Skytech
Model	5320
Category	Thermostat
Language	English