-2-
Inserting batteries:remove the battery compartment on the back of the remote
controller and insert 4“AA” alkaline batteries,paying attention to the polarity
markings in the battery compartment(batteries must be purchased separately.
battery cover
4 x ”AA”
Charging the model battery
Inserting battery
1.Insert the plug
in the socket.
1.USB connected
to the computer.
NB:The red indicator turns on when charging and green indicator turns on when
charing is complete.
NB:The red indicator turns on when charging and go out when charing is complete.
This USB can be compatible with any phones,PC (7.4V USB)for rechargeable
batteries.
2.Connect the battery
and charger plug.
-
-
+
+
Style 1: charger with balance charge 110-240V power supply.(selective buying)
Style 2:USB(standard configuration)
2.Connect the battery
and charger plug.
1.Install batteries in correct polarity.
2.Do not mix old and new batteries.
3.Do not mix different type of batteries.
4.Non-rechargeable batteries cannot charging.
5.Rechargeable battery must be charged under adult supervision.
6.Power terminal shall not be short circuit.
7.Unable to connect to more than the recommended number of
power supply.
8.Only can be used the USB cable for charging with producers
provide,USB not a model.
To Next Page
Loading...
General