-5-
1.Put out the motor wire(see fig.1)
2.Put out the cooling rubbes hose(see fig.2)
3.Screw out the motor seat screw(see fig.3)
4.Remove the motor seat module (see fig.4)
5.Hold down the main shaft rubber pieces,using a wrench
lockout and propeller(see fig.5)
6.Put the spindle away a distance in the diection of the bow(see fig.6)
7.In amoderate amount of lubrication oil to the tail of the spindle tube.(see fig.7)
8.Spindle rotating forward and backward,pulls slowly,let the lubrication oil on the
spindle tube wall evenly.(see fig.8)
9.Hold down the main shaft rubber,using a wrench tightened the screw down and
propeller (see fig.9)
10.Load the motor seat module (see the fig.10)
11.Lock the motor seat screw(see fig.11)
12.To reconnect the cooling rubbes hose(see fig.12)
13.To reconnect the motor wire(see fig.13)
To pair the boat with the remote controller
WARNING
Put the model into the water (Boat need in the water to conduction the
power ).Turn on the remote controller. The controller LED indicator will
flashing and “Di”, the remote controller will “di-do-di” the controller LED
indicator will stay constant ,it means paired with the remote controller. Then
you can play it.
fig.10
fig.13
fig.11
fig.12
NB: 1.battery wire exhaust to boat side,to prevent the wire were cut off by the steering wheel.
2.All plug need tightly.
3.insure the cabin cover tightly,prevent leakage.
1.This product is suitable for people over the age of 14. Must only operate it
when supervised by an adult.
2.Finish the voyage,cannot recharge the battery immediately until the
battery cooling.
3.When the ship sailing,insure the area without people.Cannot have aquatic
or debris in the water,avoid the propeller were caught or damage to the
ship.
4.This product have some small parts,Don’t swallow in order to avoid
choking danger.
5.Please keep a sale distance with the voidhigh speed rotating propeller ,
avoid ground injury risk.Battery matters attention.
6.Motor is a hot parts,pls don’t touch it,in order to avoid scalding danger.
7.Regularly check the USB cable and other parts for damage,should stop
using until repair intact if have something broken..