Page 6
MK SINK OWNERS MANUAL• REV4
1-8. Safety Precautions
The following is a summary of WARNINGS and
CAUTIONS indicated throughout this manual. These
precautions are found where applicable. Carefully
read this section before operating the equipment.
WARNING
WARNING with safety alert symbol indicates a
hazardous situation that, if not avoided, could result
in death or serious injury.
REPAIRS AND ADJUSTMENTS should be
attempted only by experienced service
agents fully acquainted with this equipment.
The use of inexperienced, unqualified
persons to service the equipment, or the
installation of unauthorized parts, could
cause serious personal injury, or result in
costly damage. Always unplug power cord
from power source prior to attempting any
repairs or servicing.
Handling may be awkward, we recommend
that unpacking and installation is performed
by at least 2 people.
For wall mounted units, the wall structure
must be capable of supporting the load.
Z brackets and sink support brackets must
be installed perfectly level and all state,
local, and national codes must be adhered
to ensure proper sink drainage.
Local building or plumbing codes may
require modications to the information
provided. You are required to consult the
local building and plumbing codes prior
to installation. If the information provided
here is not consistent with local building
or plumbing codes, the local codes should
be followed.
This product must be installed by a licensed
contractor in accordance with local codes
and ordinances.
FAILURE TO COMPLY WITH PROPER
INSTALLATION AND MAINTENANCE
INSTRUCTIONS COULD CONTRIBUTE TO
VALVE FAILURE.
This hot water master tempering valve
cannot be used for tempering water
temperature at xtures. Severe bodily injury
(i.e., scalding or chilling) and/or death
may result depending upon system water
pressure changes and/or supply water
temperature changes. ASSE standard 1016,
1069 or 1070 listed devices should be used
at xtures to prevent possible injury.
This hot water tempering valve is designed
to be installed at or near the boiler or water
heater. They are not designed to compensate
for system pressure uctuations and should
not be used where ASSE standard 1016,
1069 or 1070 devices are required. These
valves should never be used to provide
“anti-scald” or “anti-chill” service.
The components of the system must be
of materials with a construction capable
of withstanding the high limit output
temperatures of the water heating source.
Periodic inspection and yearly maintenance
by a licensed contractor is required.
Corrosive water conditions, temperatures
over 200°F, unauthorized adjustments or
repair could render the valve ineective
for service intended. Regular checking and
cleaning of the valve’s internal components
and check stops help ensure maximum life
and proper product function. Frequency of
cleaning and inspection depends upon local
water conditions.
Burn Hazard. DO NOT CHANGE temperature
settings on thermostatic mixing valve,
unless you are a trained mechanic. ANY
REPAIR or modication of mixing valve
may aect the high temperature setting. The
installer must check operating temperature
before sink is back in operation.
The Eye Wash System should be tested
weekly as part of normal Emergency
equipment protocol.
Exercise personal care by following the
cleaning agent manufacturers’ instructions
and wearing protective equipment. Always
consult the chemical supplier.
To Next Page
Loading...
Need help?
General