SkyVac Interceptor - Gutter Cleaning Best Practices; Top 10 Gutter Cleaning Tips

TOP 10 TIPS FOR GUTTER CLEANING
1) When you arrive on site carry out an inspecon rst with your SkyCam
so you know what to expect
2) The cleaning acon is to agitate the debris in the guer to break it into
bite sized pieces. So no need to have your camera ed at this stage
3) Always nibble forward to grab a bite sized piece then pull back, this
will give the SkyVac a chance to work and will help to avoid blockages
in the end tool
4) If you do get any blockages in your end tool simply open up the vac
release valve to allow the blockage to fall free
5) As the SkyVac cleans the inside of the poles can get coated with dirt.
Periodically bring them down and suck up 2—3 litres of fresh tap
water to ush them through
6) When liing heavy clumps of grass/earth from the guer li up slowly
and turn airside make sure below is clear and safe, open up the vac
release valve to cut the vacuum to allow the collected waste to fall to
the oor
7) If you are unsure you have sucked up everything, you can open up the
vac release door slightly to see if there is any debris passing through or
not. If nothing is going by then move on.
8) For large leaves if your end tool keeps geng blocked, swap over to
the blow funcon feature to simply and quickly blow the guer clear
9) For maximum sucon power always keep your lter clean
10) Aer the clean has been completed put your SkyCam back up to check
you have removed everything