SkyVac Interceptor - Preparation and Engine Starting; Pre-Use Checks and Preparation; Engine Oil Filling Procedure; Engine Starting Steps

PREPARATION FOR EACH USE
1) Check for petrol leaks (clean up any spillages)
2) Check HT (spark plug) lead for damage
3) Check trailing grounding lead is intact and touching the ground
4) Check oil level is correct
5) Check that collecon drum is empty, or has sucient capacity .
6) Check the lter/oat valve for cleanliness/operaon
2) Move the choke lever to the CLOSED posion.
Note the choke may not be needed if the engine is
warm or the air temperature is high
3) Move the throle lever slightly to the le
Ensure the Interceptor is on level ground. Remove
the grey dipsck and ll with mulgrade 10w 40
engine oil. Pour up to the boom of the thread in
the dipsck chamber
STARTING THE ENGINE
1) Turn the black fuel valve to the ON posion
To Fill the Engine with Oil