SkyVac Interceptor - Inspection Camera and Pole Care; Using the SkyCam Inspection Camera; Cleaning Pole Joints

Always clean your poles to ensure the joints are clean and free from
grit/dirt which may prematurely wear the joints
When cleaning, wet or damp guer dirt can
somemes sck and line the inside of your
poles. The poles will get cold to touch and
the weight of the poles will be increased
slightly. To remedy this, place the end tool in
water and suck up a small amount of water.
TIP Aer every shi, ush the inside of tubes and exi hose by sucking half a bucket of
water up into the vacuum and empty. This helps keep the pole joints clean from grit
FITTING AND OPERATING THE OPTION INSPECTION CAMERA
SkyCam Instrucons
Press the buon behind
the water proof boot to
switch the camera on
Aach the camera to the pole. You can survey the length of
guer to idenfy the depth of cleaning required then remove
camera and start cleaning. This allows you to be a lile more
vigorous with the sucon poles.
Once the clean has been completed use the camera for a quick
inspecon